Problems flashing hex file to nRF51

[bluetooth_mdw]

I just got a nRF51 and am having trouble getting started with it. I created a very simple program using the mbed compiler and produced a hex file which I now wish to flash to the nRF51. I fire up nRFGo Studio, select nRF51 Bootloader in the Device Manager window, select my hex file, select the COM port which is labelled Segger and hit Program. I get messages in the Log as follows:

Progress 0 Transmission timeout Ack out of sequence or not ack returned.

Or at least that's what I used to get. Now I'm not seeing the COM port for Segger.

Could you help me get started please?

Thank you

[Jay Tyzzer]

Hello,

Which board do you have? Please look at the white label and reply back with the PCA number.

If it is the PCA10024 then you cannot use the nRFgo studio or any other J-link type programing utilities. You will need to take your hex file and drag and drop it onto the drive that comes up when you plug in the board.

Note, if you use MDK-ARM to make your hex file and you wish to include the softdevice (Stack) then you will need to merge them prior to dropping and dragging to the Nordic Mkit board. One utility that can do that is Mergehex.exe.

JT

[bluetooth_mdw]

Hi, it's a PCA10028. Do the same rules/constraints apply for this board? If so, thank you!

Which document should I be reading to guide me in the use of this board then? I looked at various yesterday and didn't pick this up. My previous experience using Nordic stuff required me to use nRFGo Studio hence I gravitated towards it.

Thanks again, much appreciated