Program nrf52832 with pickit4

[Sunil519]

Hi, 

The product description of pickit4 on microchip website(https://www.microchip.com/developmenttools/ProductDetails/PG164140) says that it support swd. So I'm wondering if I can program nrf52832 with pickit4?

Regards,

Sunil

[awneil]

Presumably, you're asking because you already have the PICkit4 ?

Yes, it should be possible to do programming - but you're going to have to figure out how to make that work.

It's unlikely to work with any of the Nordic tools, and certainly won't work with SES.

Also unlikely that you'll get it to do any useful debugging.

And there'll be no support.

Would it not be easier to just use an nRF52 Dev Kit - which has an onboard JLink ... ?

[Sunil519]

Hi awneil,

I have been using the nrj Dks for development and testing. I came across this link : https://devzone.nordicsemi.com/f/nordic-q-a/30218/how-can-i-program-nrf82832-or-nrf82840-chip on devzone and it mentions that any programmer with SWD can be used for programming, I was curious to see if I can use pickit4.

Regards,

Sunil

[awneil]

Sunil519 said:

the nrj Dks

the what?

Sunil519 said:

I was curious to see if I can use pickit4

As already noted: Yes, it should be possible - but whether it's a good idea is an entirely different matter!

As I said, using a DK is easier and gives you more.

With the onboard JLink on the DK, you also get an evaluation licence to use Monitor Mode Debug.

[Sunil519]

Sorry, it's nRF DKs. Yes, using the JLink is the better solution. Thanks for your help.

[awneil]

You're welcome.

If your question is resolved, please verify the answer: