This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

nrf9160 at_client tag v0.4.0 solution does nothing?!?!?

I followed the recommended steps and got the at_client solution to build and flash in Segger Embedded Studio with tag "v0.4.0".

I installed it onto my board, and but didn't see anything other than "The AT host sample started" (no input allowed).  So, I pulled out my PCA10090 board, and I see the same behavior.  nRF Connect also fails on both boards.

(Edit: Side note--I successfully flashed the mfwnrf916007029alpha aka 0.7.0-29.alpha firmware to both boards)

When I open up main.c, the only thing in the main() function is:

void main(void)
{
	printk("The AT host sample started\n");
}

That sure doesn't look like it's going to kick off an AT command processor to me.  Is this just broken or am I losing my mind and there is a "New Way Cool(tm)" mechanism buried somewhere in the bowels of the zephyr configuration that does the AT processing that I'm just too old and stodgy to understand?

Thanks.

Parents Reply Children
No Data
Related