nrf9160 at_client tag v0.4.0 solution does nothing?!?!?

[Andrew Lentvorski]

I followed the recommended steps and got the at_client solution to build and flash in Segger Embedded Studio with tag "v0.4.0".

I installed it onto my board, and but didn't see anything other than "The AT host sample started" (no input allowed).  So, I pulled out my PCA10090 board, and I see the same behavior.  nRF Connect also fails on both boards.

(Edit: Side note--I successfully flashed the mfwnrf916007029alpha aka 0.7.0-29.alpha firmware to both boards)

When I open up main.c, the only thing in the main() function is:

void main(void)
{
	printk("The AT host sample started\n");
}

That sure doesn't look like it's going to kick off an AT command processor to me.  Is this just broken or am I losing my mind and there is a "New Way Cool(tm)" mechanism buried somewhere in the bowels of the zephyr configuration that does the AT processing that I'm just too old and stodgy to understand?

Thanks.

[Andrew Lentvorski]

Hi, Sigurd,

Yes, I had updated west, but that didn't seem to fix anything.

And building as an nrf9160_pca10090ns board simply wiped out any response at all.  I don't even get a "Booting" prompt anymore.

I do notice that you are on Windows and I'm building on OS X.  I'll go pull my Windows laptop and see what happens over there.

Thanks.

[RicFlair]

Im also having issues as well. Im am using Windows and get the responses below. 

I tried both applications AT_Client and Asset Tracker. 

I can build without any problems, its flashing that is the issue...