Analog prescale question

[Frank Zhao]

I'm using a nRF51844

I'm writing my own ADC reading routines because I can't find any examples, but I know how to code so that's not a problem. I just want to confirm something:

If the analog reference is selected to be ADC_CONFIG_REFSEL_SupplyOneThirdPrescaling , then does that mean to get a one-to-one reading, I should be using ADC_CONFIG_INPSEL_SupplyOneThirdPrescaling as well? If I do this, I assume that if my VDD is 3.3V and input is 3.3V, I get a 10 bit reading of 1023, correct?

What are the tolerances on the two prescalers?

[Stefan Birnir Sverrisson]

If you have VDD (supply voltage) as reference by choosing e.g. ADC_CONFIG_REFSEL_SupplyOneThirdPrescaling, the ADC will compare the input voltage to the supply voltage. If you choose ADC_CONFIG_INPSEL_AnalogInputOneThirdPrescaling then that would mean the ADC will output 1023 when the input voltage is equal to the supply voltage when sampling with 10 bit resolution. However, it would make no sense to choose Supply voltage for both reference and input, as you have suggested.

For ADC saturation points and maximum voltages on the analog input pins, please look at: devzone.nordicsemi.com/.../what-voltage-range-can-be-measured-with-the-adc

[Frank Zhao]

my mistake, i think i did mean to write ADC_CONFIG_INPSEL_AnalogInputOneThirdPrescaling but copied the wrong line

thanks for the reply

is there any error specifications on each individual prescaler?