Hello sir ,
I have conneccted an BLE400 dev kit to an swc J-flash device. And i can't erase it.
Tried with nRFgo Studio on windows 10 an with linux nrf cmd line commander .
Same result , it's not working
Best regards
log.log
I do not know if the "swc J-flash device" supports the nRF51822. Have you tried using a nRF51DK as the programmer?Also what Jlink driver version are you using?
I don't have idk , only the ble400 dev kit
It's an J-link V9 device with j-link commander 6,47 software.
It would be a lot easier if you did use the Nordic Dev Kit: then you would have a full set of ready-to-go examples, and known hardware - so people could more easily give you support.
dlnraja said:only the ble400 dev kit
From your link, the BLE400 is just the motherboard - do you also have a wireless module on it ?
"J-link V9 device with j-link commander 6,47 software."I need the J-link driver version number.
i have an
j link 6,47c best regards
