When use app_button lib,the button setting using PULL_UP consumes more current (~20uA) than using PULL_NONE

[Pupil]

The button is connected to ground directly ,and without external pull up resistor.

I found it consumes too much current when using internal pull up resistor,but when I use an external resistor,it's the same.

When changing the gpio setting to PULL NONE ,the current is ok,but the button can't work.

Really confused.

[Turbo J]

PCB not cleaned after soldering and now there is a parasitic resistance somewhere?

Otherwise: Schematic required, maybe even layout.

[Pupil]

I measured the volt of the ,it's about 0.4v lower than the vdd ,the current is flow through the pullup resistor.