Hi Hasan Sorry about the misunderstanding. You want to increase the range of your application, am I correct? If so, which chip are you using? If you're using the nRF52840, you should be able to change the BLE_GAP_PHY setting to BLE_GAP_PHY_CODED, which is "long range mode", a test using this mode is described in this blog post. This mode outputs around 125kbps and is tested outdoors to work at ~1300 meters. If you're using an nRF52832, you could set the BLE_GAP_PHY to always be at BLE_GAP_PHY_1MBPS as well as increasing the TX power for the longest range possible. In both these cases, you should probably remove the change_PHY and PHY_UPDATE events from the main file in the image transfer demo. Best regards, Simon

This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

(can not scanning for device.)

HasanYilmaz over 5 years ago

Top Replies

Simonr over 5 years ago +1 verified

Hi Hasan Sorry about the misunderstanding. You want to increase the range of your application, am I correct? If so, which chip are you using? If you're using the nRF52840, you should be able to change…

Parents

0 Simonr over 5 years ago

I need you to be more specific here. Why would you need to send a picture by the press of a button if you are doing it automatically when the device is connected? Do you want to start a stream or just send a single picture when pressing a button, and what button are you referring to?

Best regards,

Simon
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 Simonr over 5 years ago

I need you to be more specific here. Why would you need to send a picture by the press of a button if you are doing it automatically when the device is connected? Do you want to start a stream or just send a single picture when pressing a button, and what button are you referring to?

Best regards,

Simon
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data