How can i Control LED in nRF9160 SIP Without using any Microcontroller ?

[jaydip kavaiya]

Hi 

              We are designing a custom board using only nRF9160 as a tracking device.
               I am connecting Switch and LED to generate various events.
               Is is possible for me to program nRF9160 module without using any controller in the device. (Programming to control LED)
               We will be sending a data through LTE whenever any defined events are notified by Switches and LED.

[Martin Lesund]

Hi Jay,
The nRF9160 has a Cortex M33 and 1MB of Flash for your disposal to have your application on.

Please take a look at the Asset Tracker Application where you send simulated "flip" data when the Switch1 on the nRF91DK is switched.

Please take a look at our tutorials:
- Getting Started with nRF9160 DK

- Getting started with NCS

[jaydip kavaiya]

Hi Martin,

                 Thanks for the replay. We are designing a custom board using only  nRF9160sip( system in package) 

and some LEDs and Switches Not use nRF9160 Development Kit. I read and Set All the Environment Getting Started with nRF9160 dk So i just want to know how to directly programming into nRF9160(SIP).

I install Following 

*   Embedded Segger Stdio  

*   nRF Connect Stdio 

*   Getting Started with Assistant

*   Asset Tracker Application.

But i think this all are for Development kit.

so i am confuse how to directly programm in to nRF9160 sip.