Testing on Modules of Alert Notification Application and Immediate Alert Client Application

[swathi p]

Hi Sir/Madam,

I tried testing Alert Application notification by performing mentioned testing steps but after i reach 4th step i.e Bond to the device from nRF Connect (the device is advertising as 'Nordic_Alert_Notif'). To bond, click the settings button for the server in nRF Connect, select "Security parameters", check "Perform Bonding", and click "Apply". Then connect to the device. Observe that the BSP_INDICATE_CONNECTED state is indicated.

Problems noticed:

1)Unable to find device advertising as 'Nordic_Alert_Notif' 

2)Unable to observe  BSP_INDICATE_CONNECTED state is indicated.

 

I also tried testing  Immediate Alert Client Application and followed mentioned steps but coudn't find <InstallFolder>\examples\ble_peripheral\experimental\ble_app_ias_c folder. Load the file findMeMasterServer.ncs. but it is found to be in nRF5_SDK_15.3.0_59ac345\examples\ble_peripheral\ble_app_ias_c tried loading findMeMasterServer.ncs from this folder.

and then tried to connect to the device named nRF Connect but when i press button 1 and observe change in value is not noticed as mentioned.

Thank You.

[AndreasF]

Hi.

Have you programmed / flashed the Application correctly?

You should see it advertising.

Best regards,

Andreas

[swathi p]

Hi,

NOTE:The application program is from SDK 15.3.0 and in that related softdevice is of V6.1.1

yes,I programmed the application by following mentioned procedure.But,intially when i select the device through nRF Connect(desktop) I was asked to program the device and then i clicked 'yes' and i observed in the log it  displayed that v3 of softdevice is downloaded ,when i click 'no' nRF Connect(desktop) is getting crashed.

what might be the misleading factor?

Thank You.

[AndreasF]

Hi.

You need to have two devices, one device you program the application on, the other device you open in nRF Connect for Desktop and program with that.

Best regards,

Andreas

[swathi p]

Hi,

Ok Thank You for making clear.If you have already mentioned this point before performing required steps to test it might not lead me to ask you this question.

If i have single board please suggest me whether it is possible to test Alert Notification services?if so,then how?

Thank you. 

[AndreasF]

Hi.

Yes, you can download the mobile application named nRF Connect and use that instead.

Best regards,

Andreas