This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

PCA10031 firmware update failed

Hi,

I would like to use PCA10031 to be a sniffer. It can't update and show as below figure.

I've also refer to discussion as below website to turn it into BOOTLOADER mode and then copy-paste the newly version of J-Link OB-SAM3U128-V2-NordicSemi 170724.bin into PCA10031.

https://devzone.nordicsemi.com/f/nordic-q-a/8144/i-can-t-update-the-j-link-ob-firmware-nrf51-dk

The LD1 keep blinking after firmware update. Is it correct?

Parents

0 Amanda Hsieh over 5 years ago

Hi,

The J-Link OB firmware version seems they are the same, J-Link OB-SAM3U128-V2-NordicSemi. Only the compiled day is different. I think that might be the reason.

According to the page7 in the https://infocenter.nordicsemi.com/pdf/nRF_Sniffer_UG_v2.2.pdf:

Verify that the Sniffer firmware is running correctly by checking that LED1 toggles each time a packet is received. At least one device must be advertising for the Sniffer to detect the advertisements.

-Amanda H.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 Amanda Hsieh over 5 years ago

Hi,

The J-Link OB firmware version seems they are the same, J-Link OB-SAM3U128-V2-NordicSemi. Only the compiled day is different. I think that might be the reason.

According to the page7 in the https://infocenter.nordicsemi.com/pdf/nRF_Sniffer_UG_v2.2.pdf:

Verify that the Sniffer firmware is running correctly by checking that LED1 toggles each time a packet is received. At least one device must be advertising for the Sniffer to detect the advertisements.

-Amanda H.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data