Master Control Panel with nrf51 dk

[harry]

Hi everyone,

I have a nrf51-dk. I am running Master Control Panel app on my win7 computer. However, I cannot see my nrf51-dk in discovered devices section. Log says, Loading...,No response from master emulator,SERVER:Server has started.

When I click to Start discovery button, I keep getting "No command complete event received".

Can anybody help me out with this problem. I am stuck right now.

By the way, I have mefw_nrf51822_0.9.0_firmware.hex for Programming of SoftDevice on nrf51 device.

Thanks for your replies!

[GlennEngel]

I had the same problem (yes, I had the P0.30 jumper). In my case I got a prompt to update the firmware when running MCP 3.10.0.14 and accepted the prompt. After that, I could never Start Discovery without the errors.

I downloaded the J-Link Configurator App and attempted to update the firmware. It said it could not update because the firmware in the PCA10028 was newer than what the JLink configurator had.

I then right clicked the PCA10028 board in the J-Link configurator and said 'replace' the firmware.

After that, all was well again with the world and MCP worked properly. I now decline to update the firmware when MCP starts.

[GD]

It worked for me. Thanks!