twi_sensor sdk example doesn't get any data???

[Eisenheim]

Hi,

I am using nRF5_SDK_15.3.0_59ac345 for nRF52840 DK. I am running the sdk example "nRF5_SDK_15.3.0_59ac345\examples\peripheral\twi_sensor" on nrf52840. When I am opened a serial terminal on putty It doesn't get any data. Any suggestions......In the attached image below after the highlighted  portion doesn't executed.I am getting m_xfer_done as false value.

Regards,

Eisenheim

[awneil]

Have you tried the TWI scanner example to verify that your nRF can actually see the sensor?

Have you used an oscilloscope  or analyser to see what's happening on the wires?

https://devzone.nordicsemi.com/f/nordic-q-a/49484/nrf52832-communication-with-esp8266-over-i2c/197068#197068

How to properly post source code - not as an image!

[Eisenheim]

Hi awneil,

Thanks for your suggestions.

I am  tried the TWI scanner example. I get the output as "No device was found." Is my sensors are working not properly?

[awneil]

That shows that your code is not communicating with your sensor.

There are many possible reasons for that - so you need to test, investigate, and debug to find out what is going wrong.

Again, an Oscilloscope will be indispensable in that ...

How To Debug

[Eisenheim]

Ok Thank you so much awneil. In nRF52840 by default any sensors are connected to TWI?

[awneil]

nRF52840 is just a chip - it has nothing connected at all!

For details of what's on the Dev Kit, study the User Manual and the Schematics.

[Eisenheim]

Thanks for your Quick Reply Have a Nice day.....