compiling ble_app_interactive_s140_pca10056

[ella482]

When I go to compile the ble_app_interactive_s140_pca10056 example on segger for my nRF52840 DK, which is a .emProject, the .c files are not registering .h files. I compiled the ble peripheral example "beaconing" using the same method, but the ble_app_interactive_s140_pca10056 isn't working. Any suggestions?

[Susheel Nuguru]

I compiled this on the clean unzipped SDK15.3 and it compiles without any error.

[ella482]

It worked when I tried it again! thank you!!! Now I am trying to connect it through putty. the soft device and program are correctly programmed. The only trouble is that the computer is not recognizing the dongle when it is programmed with these two items. It works with the cli peripheral example, but not this one.

[awneil]

You can't just load PC10056 (DK) code onto PCA10059 (Dongle) - you need to reconfigure, and rebuild.

Although the nRF chip is the same, the board hardware around it is different.

[ella482]

Thank you! I am connecting a uart cable to the back to try to run it this way.

[Susheel Nuguru]

ella482 said:

I am connecting a uart cable to the back to try to run it this way.

 ello482, not sure if I understand what you said, but is this the comment to Andrew's reply? 

If so, please explain in detail how that solves the problem he mentioned below?

awneil said:

You can't just load PC10056 (DK) code onto PCA10059 (Dongle)