TWI error when SDA on Port 1

[MartinP]

Hi everyone,

I'm using a Si7051 I²C temperature sensor connected to a nRF52840 and I found some very weird behavior of the TWIM module. Firmware-wise I'm using the mbed framework with the blocking I²C functions.

Writing data to the slave works fine, but reading data from a slave results in the nRF's SDA pin trying to output a low-impedance high level and therefore blocking further I²C communications (6mA measured between slave and nRF). Bluetooth seems unaffected by this short and continues to operate (meaning the softdevice is active, I've read some reports that some I²C functions depend on the SD)

What's strange is that this only ever happens with the SDA pin on Port 1.

SDA and SCL both on Port0: works
SDA on Port0 and SCL on Port1: works
SDA on Port1, SCL on either: fault

I didn't find any info relating to the TWIM in the errata. If possible, I'd like to avoid ordering a new run of prototype PCBs.

Cheers,
Martin

[Edvin]

Hello Martin,

Does this only happen in the embOS examples? Have you tested on a Nordic SDK example as well?

when you say Port0 and Port1, are you referring to the P0.xx and P1.xx on the nRF52840 DK?

Best regards,

Edvin

[MartinP]

Hi Edvin,

yes, I'm referring to P0.xx and P1.xx. Further testing showed that this only occurs with mbed, other frameworks seem to work fine with the same hardware. I'll take this to their issue tracker.

Best,

Martin