mdbt42q bluebee module having issue in toggling GPIO pins...

[Heena]

Hello, 

I am using nrf52832 board, having SDK 15.3.0, in Segger studio IDE, on windows10.

I am using bluebee board in which mdbt42q chip is used.I am trying to toggle gpio pin number P0.11, P0.12.

Observation

P0.11 is toggling from 0V to 3.3 V

P0.12 is toggling from 2.7V to 3.3V.

Why it is not toggling??

If possible can i get the datasheet for the module..??

Regards,

Heena Jadaun

[Sigurd]

Hi,

Heena said:

Why it is not toggling??

Maybe the pin is connected to something, there is an asterisk (*) next to the pin number, so it could e.g. be connected to some UART-USB bridge or similar. You would need the datasheet or schematic to confirm it.

Heena said:

If possible can i get the datasheet for the module..??

The bluebee board is according to this website produced by Atoll Solutions. You would need to contact Atoll Solutions to get the datasheet.