nRF82832- BL652

[guma]

Hi,

I am new to the nordic platform .I am using. BL652 modules .I was able to blink my on borad LED and then made the device as peripheral to advertise with the device name .Im able to advertise the device successfully.(used nrf connect app).

I now will make another module of BL652 as central and scan the advertiser and i want to check the RSSI values so how can i display the perpherial device name and RSSI after scanning ?

how do i use the uart interface at the central/peripheral to display messages in COM port.?

At the peripheral side how do i change the TX power level? 

Thanks.

Regards,

Uma

[Simonr]

Hi Uma

This case is very similar to yours and explains how to implement RSSI printing from peripheral to a BLE/UART central. The sd_ble_gap_tx_power_set() function allows you to set the TX power per connection. For more info on TX power settings, please see this thread.

Best regards,

Simon

[guma]

Hey,

If i have to just scan the advertising packet and not any further connection.

what changes need to be done in ble_adv_report?

how much should be the advertising and scanning interval and window?