[Zigbee]How to know if it using the install code instead of the default TC link key?

[SongSie]

Hi,

  There is a Demonstration about zigbee joining networks by install code.

But how to know if it using the install code instead of the default TC link key?

1. I run the nrf52840 dongle cli example:  .

2. Then run the 52840 DK, this is the rtt viewer : . the log "ic set ok." is tell me the fuction zb_secur_ic_set() is called and return RET_OK.

3. I reset all, then set "bdb ic policy enable" like this :

4. The ZED's rtt viewer :

5. The ZED joined network seccessfully after type  "bdb ic policy disable".

Thanks.

Song

[AndreasF]

Hi again Song.

I've forwarded the issue to our developers so that they can have a look at it.

Please be patient.

Best regards,

Andreas

[SongSie]

Andreas,

  Thank you very much.

Song

[AndreasF]

Hi Song.

I've had a look at it, and it seems like you are using the wrong eui64.

The eui64 you should use in the bdb ic add is for the joining node.

Best regards,

Andreas

[SongSie]

Andreas,

Yes,I made a stupid mistake.

The problem is solved.

Thank you again.

Best regards,

Song