nrFgo Studio does not detect J-link

[alex_u]

Hello,

I have problems using nrFgo Studio with my J-link programmer. The "nrf5x Programming" section is greyed out when the j-link is connected to the PC and the MCU.

I am using Windows 10 with nrfgo studio 1.21.2.10 and have the J-link Driver Version 2.70.8.0 installed and a nrf52832 IC connected over SWD interface.

I tried removing and installing the driver and nrfgo Studio but it did not solve the problem.

nrfjprog, keil and all the segger tools work flawless.

The jlink works also on my colleagues PC with win7 and the same nrfgo version.

Is there anything else I can try to get it to work?

[Vidar Berg]

Hi,

You may try to install the 32-bit version of command line tools and see if that helps. But nRFGo studio is replaced by the Programmer app in nRF Connect for Desktop so I'd recommend you to try that instead.