[pc-ble-driver]Build connectivity library

[Torsten Robitzki]

Hi,

I try to develop a fix that should allow me to use the pc-ble-driver to receive scan responses (see https://devzone.nordicsemi.com/f/nordic-q-a/50082/pc-ble-driver-no-scan-response). So I have to make some fixes to the connectivity firmware. I base my work on the nRF5_SDK_15.3.0. I've applied successfully the patch that comes with the pc-ble-driver (nRF5_SDK_15.3.0_connectivity.patch) and I successfully build the usb_with_s140 version of the firmware (which should correspond with the makefile in examples/connectivity/ble_connectivity/pca10056/ser_s140_usb_hci/armgcc in the SDK).

I've deployed the SD140 and the firmware to a PCA10056, I connected P0.18 and P0.24. When I connect the PCA10056 from the nRF USB Connector to my MacBook, I can't see any additional device under /dev. When debugging the firmware, it loops in `usbd_enable()`.

Any idea, what I'm doing wrong here? Any recommendations on how to make  changes to the connectivity firmware required by the pc-ble-driver?

Thanks in advance,

Torsten

[Jørgen Holmefjord]

Hi,

How did you apply the patch? Did you verify that the changes were successfully added to the files in the SDK?

What did you connect P0.18 and P0.24 to?

Best regards,
Jørgen

[Torsten Robitzki]

Hi Jørgen,

I've applied the patch manually, using "git apply ....". There where no error messages and as I put the SDK under git controll, I could see that this changed a lot of files.

I connected P0.18 to P0.24 using a wire.

[Torsten Robitzki]

Hi Jørgen,

you can close / delete this case. We have decided to remove pc-ble-driver from our product design.

Thanks for your time,

Torsten