Reasons of having Models and elements in Nrf Mesh Protocol

Question

I have one doubt that why there is elements or models in Bluetooth, it can be simple as sending messages and then translate them into useful work, in this single element and model needed, no need to worry about future expansion in code side if it provisioned or not. 
 I searched many time for this reason but didn't get answer. I asked Bluettoth SIG about it, but didn't get response from there. 
 How models are better than one single model with only trans receive of messages and then use message as need. 
 I didn't means that Models are wrong or anything else, and I know if it is standard, then there must be reason for it. I want to know that reason. 
 Please if anybody have knowledge about logic behind models, then please explain. 
 Thank You 
 Bivay

tesc · Accepted Answer

Hi, 
 Models provide a framework for modeling the data that you want to send and receive. It fills the same role as GATT Services do in Bluetooth Low Energy (BLE). As with any communication protocol, you need a way to pack your payload into units that are understood in both ends, and for Bluetooth mesh this is done through the Mesh models. 
 There is a set of models that are specified by the Bluetooth SIG. One of the goals of defining those models is to ensure compatibility between devices from different vendors. 
 In addition to the Bluetooth SIG models, you are free to make your own (vendor specific) models covering your needs. This gives you the flexibility to implement whatever you want, when you do not need the compatibility of the SIG models. 
 Messages from SIG models and vendor specific models are treated equally over the network, as the lower stack levels are agnostic to what model a message belongs to. 
 In our nRF5 SDK we have made a "UART over BLE" Service for providing a general two-way byte stream between two BLE devices. You could do something similar for Bluetooth mesh. Note however that throughput in Bluetooth mesh is low compared to BLE. 
 Regarding the reason why Bluetooth mesh is made this way, I think in huge part it boils down to the fact that GATT Services has been a success in BLE (and still is.) 
 Regards, Terje

awneil · Answer

bivay said: why there is elements or models in Bluetooth 
 Because, as explained in your previous post, that is the way the Bluetooth SIG defined it! 
 https://devzone.nordicsemi.com/f/nordic-q-a/51801/why-there-is-models-in-mesh-communication-nrf52832 
 bivay said: didn't get answer 
 Yes, you did: 
 https://devzone.nordicsemi.com/f/nordic-q-a/51801/why-there-is-models-in-mesh-communication-nrf52832/208231#208231

Reasons of having Models and elements in Nrf Mesh Protocol

Top Replies