How to make a Bluetooth Hub for IoT using nRF 52 DK and Wiznet5500 ethernet board?

[Sreeraj]

I am following https://github.com/Wiznet/nRF52DK_to_W5500Shield for the connectivity. Is there any tutorial specific for my use case?

[awneil]

Isn't that Github page the tutorial?

Did you follow the Wiki link?

Have you contacted Wiznet - as it's their project (not Nordic's) ?

[Sreeraj]

Yes, it is. But If I want to change something in the nordic side may be to create it as a Bluetooth mesh connected to the same hub. What all things I should be careful about?

[awneil]

As with any software development, you will need to be familiar with the target and its tools.

You will need to be a proficient embedded 'C' developer.

Nordic Getting Started:

https://www.nordicsemi.com/Get-Started

https://devzone.nordicsemi.com/nordic/short-range-guides/b/getting-started/posts/introduction-to-bluetooth-low-energy-and-ble-devel

Regarding Mesh:

https://devzone.nordicsemi.com/f/nordic-q-a/41552/ble-mesh-to-transfer-sensor-data-using-nrf52840