SEGGER Embedded Studio, flashing device

[David]

Hi!

Just want to ask if anyone have had the same issue as me, when flashing nRF9160 with J-Link V6.50.

In SEGGER Embedded Studio - Build -> Build and run || Target -> Download file -> Download Intel Hex file

I have to manually erase the chip before flashing, when I do as above, it cannot erase by itself.

I have to select - Target -> Erase all

- David

[awneil]

David said:

it cannot erase by itself

Why not?

Are you getting any error messages?

[David]

Hi Awneil,

Yes, see below image

- David

[awneil]

Would have been useful in the OP!

Can you program from the Segger standalone utilities ?

[David]

NRF9160 SES 4.18 flash erase hanging

Suggested Answer

Hi, Since migrating to SES 4.18 erasing of the flash hangs unless the JLink is unplugged and plugged in again. This is both on the DK and our own custom board. Here's the repro steps: - Compile application…

By GJSea over 5 years ago in Nordic DevZone > Nordic Q&A

10 replies

Latest by GJSea over 5 years ago