Error when turn on sensor with TWI

[HuanVH]

I need to save energy for my ble application. So I turned off the sensor when there was no ble connection. A ble connection is a condition for me to turn on the sensor, but I cannot connect to the peripheral, when placing a connection command on nRF Connect, the debugger reports "Memory read failure".
Whether declared or not declared i2c, the phenomenon still occurs.

I am using a port to turn on and off the si7021 sensor as shown below:

When the central connection comes in, during the BLE_GAP_EVT_CONNECTED event I will turn on the sensor by setting the output of port 15 to 1. I have a problem connecting, the debugger does not report an error. Chip rebooted.

I am using twi with library twi_sw_master.c. So how do I turn this sensor on and off? Please help me, thanks a lot

P/s: nRF52832 s132 ver 6.1.1 SDK 15.3

[Jørgen Holmefjord]

Hi,

Any particular reason you are using a deprecated software (bit-bang) TWI driver? There are new (HW) drivers located in nRF5_SDK_15.3.0_59ac345\modules\nrfx\drivers\src - nrfx_twi.c and nrfx_twim.c, and these can also be used with the legacy API found in nRF5_SDK_15.3.0_59ac345\integration\nrfx\legacy\nrf_drv_twi.h.

If the chip rebooted, you most likely ended up in the error handler. Please check out this post about debugging errors.

Best regards,
Jørgen

[HuanVH]

When I use the latest version. The scl, sda pins are all pulled up to vcc, which makes the sensor still work, because my hardware has SCL and SDA suspension resistors.
And one more thing is, when I turned the sensor on and off, even though i2c was not declared, the chip was still restarted.

[Jørgen Holmefjord]

HuanVH said:

And one more thing is, when I turned the sensor on and off, even though i2c was not declared, the chip was still restarted.

Like I said in my answer above, the chip will only restart if an error is reported. Please debug the application to find which function is reporting an error.