State Verified Answer
Locked Locked
Replies 2 replies
Subscribers 73 subscribers
Views 3144 views
Users 0 members are here

Attachments (0)

Nordic Case Info

Case ID: 105359

Options

This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Programming nRF51822 using UART

ting² over 10 years ago

Hi, I am using nRF51822 with softdevice. I would like to load the program into the flash through UART, is it possible?
Thanks in advance

Top Replies

Asbjørn over 10 years ago +1 verified

Yes, this would be possible, but you have to enable the bootloader that supports UART to do so. We have example code for this available. Please have a look in the documentation here.

Parents

0 Asbjørn over 10 years ago

Yes, this would be possible, but you have to enable the bootloader that supports UART to do so. We have example code for this available. Please have a look in the documentation here.
Cancel
Vote Up +1 Vote Down

Cancel

Reply

0 Asbjørn over 10 years ago

Yes, this would be possible, but you have to enable the bootloader that supports UART to do so. We have example code for this available. Please have a look in the documentation here.
Cancel
Vote Up +1 Vote Down

Cancel

Children

0 ting² over 10 years ago in reply to Asbjørn

Thank you for your answer. I finally find the example code .
Cancel
Vote Up 0 Vote Down

Cancel

Related