Changing project from nRf52832QFAA to nrf528332QFAB

[Shimon_nohayo]

Hi,

I'm using Kail and I have a project with original target device nrf52832xxAA, I need to change it to nrf52832xxAB (the device onboard is nRf52832QFAB).

When I change it - the Jlink stop beeing recognized by Kail 

Please advise 

[Simonr]

Hi Shimon

In addition to choosing the correct device, you'll need to set the target size settings, so you'll have to halve the size for your project in IROM and IRAM under the Target tab as well. You might also have to change the start addresses depending on which SoftDevice you're using. Please see our adjustment of RAM and Flash guide for guidance on this.

Best regards,

Simon