UART and mesh

Question

Hi Team, 
 
 I am working on Mesh SDK 3.10, I have requirement of mesh with Ble Uart. So I decide to take this example "ble_app_uart_coesixt". I build this example without any error and burn it on development board. when I Nordic toolbox (UART), I see device and connect it. and everything is OK. But when i use BLE mesh app to provision this device, I am not getting device list while scanning by mesh app. 
 Please suggest me the best approach towards it. my requirement is to control BLE mesh by giving command using smart app.

tesc · Accepted Answer

Hi, 
 I am sorry for the delay. Hung is currently out-of-office and I will handle this thread while he is away. 
 The "UART data" is through BLE using the Nordic UART Service (NUS). With NUS, you send and receive data using RX and TX characteristics. You must connect to the device using BLE, for instance from a smartphone with nRF Connect, and then you can control the lights by writing numbers to the UART RX characteristic as described at the bottom of the "Testing the example" section of the SDK UART coexistence example documentation . 
 Regards, Terje

Hung Bui · Answer

Update: Example for UART in mesh: https://devzone.nordicsemi.com/f/nordic-q-a/59428/adding-uart-code-to-the-light-switch-server-project/241688#241688 Example for GATT proxy in coexistence example: devzone.nordicsemi.com/.../235538

UART and mesh

Top Replies