Hi,
I am using ncs 1.0.0 and Modem FW version 1.0.1.
I am using UART 2 and i have kept UART TX and RX port 0.11 and 0.10 in overlay file.
I want to change the port pins at run time to 6 and 5.
Is it possible to do that ?
Regards,
Smitesh Mali
Hi,
I am using ncs 1.0.0 and Modem FW version 1.0.1.
I am using UART 2 and i have kept UART TX and RX port 0.11 and 0.10 in overlay file.
I want to change the port pins at run time to 6 and 5.
Is it possible to do that ?
Regards,
Smitesh Mali
Hi Smitesh,
Can disable the UART in runtime and then change the pins and then enable the UART peripheral again with the help of setting the registers found in the documentation.
example: