• State Verified Answer
  • Replies 2 replies
  • Subscribers 73 subscribers
  • Views 1331 views
  • Users 0 members are here
Attachments (0)
Nordic Case Info
  • Case ID: 105435
Options
This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

pca10028 2 layers

daniel

Hello,

I'm redrawing and routing my own PCB for nRF81x22. I take the details from pca10028 files.

My question: Can I route the PCB with only 2 layers?? I have seen only Power layer and GND, but I guess they are not extrectly necessaire... If I remove them and less TOP and BOT and respecting the RF part as it is, no problem, isnt??

Thank you!

daniel

Parents
  • 0

    You can safely create a PCB with only 2 layers. I have done the same, where i started with the reference design for the PCA10001 board, and removed the two middle layers. Keep in mind that the top and bottom layers should have the same distance between them, and that the RF-part should be identical. Also, if you don't need the coax cable connector, I would suggest using the PCA10001 files as a reference.

Reply
  • 0

    You can safely create a PCB with only 2 layers. I have done the same, where i started with the reference design for the PCA10001 board, and removed the two middle layers. Keep in mind that the top and bottom layers should have the same distance between them, and that the RF-part should be identical. Also, if you don't need the coax cable connector, I would suggest using the PCA10001 files as a reference.

Children
No Data
Related
Terms of service