This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

nRF52840 (Holyiot-17120) cannot run code without debbuger

Hi guys,

i'm trying to deploy a BLE iBeacon on an Holyiot-17120 board. My code runs fine on the nRF52840 USB Dongle DK, but on this board works only when I've debugger attached (i'm using Raspberry Pi0 with OpenOCD to flash the HEX code). Softdevice is the latest avaliable from SDK 16, latest SEGGER IDE (4.30a). 

Attached my code and sdk_config.h.

I've already tried to disable  NRF_LOG_ENABLED but without success.

Thanks in advance!

sdk_config.hYJ-17120-nRF52840 datasheet.pdf

Parents Reply Children
No Data