NRF52832 module Interoperability

[PKSHER]

Hi guys, I want to know that if I have one board that has rigado bmd 350 module that has nrf52832. But currently I donot have access to the board, so If I write firmware on nRF52832 Module MS50SFB keeping in mind the pinout of my board, can I use the same firmware on the rigado bmd 350 module?

regards,

[bjorn-spockeli]

Hi PKSHER, 

If you develop the application code with nRF5 SDK, then you should be able to run the code on both the BMD 350 and the MS50SFB. Both modules does not have the external LF crystal so I do not think that any changes are necessary in terms of the SoftDevice initialization code at all. Both modules also support the same number of GPIOs so thats fine as well.

Best regards

Bjørn

[PKSHER]

Ok, thanks, and also the process for uploading the firmware on both the modules will be the same. isn"t it?

[bjorn-spockeli]

Yes, through the SWD interface.

Best regards

Bjørn

[PKSHER]

You have been very helpful. I appreciate it. One last question though, can I use stlink v2 dongle or any jlink/swd programmer in various development kits for programming this module, or do I need to purchase a new one? In the case of new one, kindly suggest one.

[bjorn-spockeli]

Any Jlink programmer should be fine, i.e. any one of the programmers listed here: https://www.segger.com/products/debug-probes/j-link/models/model-overview/

Best regards

Bjørn

[PKSHER]

I appreciate your good support.

Regards,