This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

Get thread topology through wpantund | wpanctl.

Hi, all

I'd like to get the whole thread network topology (like nRF_TTM does) on raspberrypi, can this function be realized with wpantund or wpanctl?

Is "wpanctl mfg..." command could work for this? I could not find more information for this command.

Is there any detail reference documents I can study for?

Thanks in advance for any help!

Parents
  • Hi,

    Have you seen the 'Principle of operation' section at the infocenter page for the TTM? Using CLI commands you can print a table of attach routers in a network and then print the diagnostic information of each router and child.

  • Thank you, msromero

    Sure, I know how to get the diagnostic information of all nodes using CLI commands, but do not know how to get these informations when using NCP commands (on the Raspberrypi board). Does NCP also support CLI command?

Reply
  • Thank you, msromero

    Sure, I know how to get the diagnostic information of all nodes using CLI commands, but do not know how to get these informations when using NCP commands (on the Raspberrypi board). Does NCP also support CLI command?

Children