This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

Port 1 pins could not assign on uarte

When i used Port 0 assigned on Uarte rx tx pin , everything was ok.

But when i changed the rx tx pin to port 1 , for example p1.00,p1.08.p1.09, it doznt work...

i am sure i used the right macro for pin map NRF_GPIO_PIN_MAP().

this problem seems like an previous bug called "Port1 could not assgin on low power pwm",please just search it for sure in devzone.

my sdk is 15.3.0 for zigbee and thread.

Thanks.

Parents
  • Hi

    Thank you for specifying. The issue you linked to seems to be specific to the mesh SDK, but I'll check internally to make sure whether it could be present in the zigbee/thread SDK as well or not. In the meantime, are you getting any error messages when using these pins? If so, could you please share what this error is?

    Best regards,

    Simon

Reply
  • Hi

    Thank you for specifying. The issue you linked to seems to be specific to the mesh SDK, but I'll check internally to make sure whether it could be present in the zigbee/thread SDK as well or not. In the meantime, are you getting any error messages when using these pins? If so, could you please share what this error is?

    Best regards,

    Simon

Children
No Data
Related