Hi Guys!
I have nRF52840 Dongle (PCA10059) 1.2.0. I downloaded Nordic exmaples repository.
I try to however start and load any HEX file with program from Nordic repository e.g. ...\nRF5_SDK_16.0.0_98a08e2\examples\ble_peripheral\ble_app_blinky\hex\ble_app_blinky_pca10059_s140.hex.
I followed the instructions as are shown on the website below:
I opened "SEGGER Embedded Studio for ARM 4.30c" program and I opened project with "ble_app_blinky_pca10059_s140" application.
Then I changed parameters of Preprocesor and Linker as it is shown in the insteructions in the tutorial but with no results and occured errors during "writting" process in the nRF Connect v.3.3.0 [Programmer]:
ERROR Reopen device failed: Timeout while waiting for device F406F48F308A to be attached and enumerated
INFO Nordic DFU Trigger Interface was not found.Please physically reset device.
ERROR Device not found due to failure during DFU
INFO Target device closed.
Whats is going wrong?
If you have any question or you need more information - please ask me about more details here.
I wil be grateful for help and support in this case.
Best regards,
Jakub