Hi,
I am using 52840 (WLCSP package) in a design. I am a hardware guy and no SW guy has been assigned to this yet. Can you please check my SPI pin assignment below and let me know if there is any issue.
CS => P0.15 (K7)
MISO => P0.14 (J7)
MOSI => P0.13 (H7)
SCLK => P0.12|TRACEDATA1 (G10)
I am not planning on using TRACE port.
Best regards,
While in the datasheet there are recommended usage of pins for QSPI, I think the pins I am using here are for the QSPI (my apology if this was not clear). So the question becomes
- Should I follow the recommendation in the datasheet, or can I assign QSPI pins like I did?
- If it is ok to use the way I used them, would there be any drawback?
Thanks again!
The recommendation from the DS is attached.
While in the datasheet there are recommended usage of pins for QSPI, I think the pins I am using here are for the QSPI (my apology if this was not clear). So the question becomes
- Should I follow the recommendation in the datasheet, or can I assign QSPI pins like I did?
- If it is ok to use the way I used them, would there be any drawback?
Thanks again!
The recommendation from the DS is attached.
