This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

Segger Tool Tip

I'm using Segger Release 4.30c.

It's difficult to describe what I'm seeing , however it's certainly making our code unreadable.

I'm setting values inside prj.conf such as CONFIG_GPS_CONTROL_FIRST_FIX_CHECK_DELAY within our GPS code.

Whilst using v1.0.0 of the SDK if I rolled the mouse over the value mentioned above I would see the actual value assigned to it.

When using v1.1.0 of the SDK nothing shows up.

In addition other values set inside kconfig inside ncs/nrf/drivers/nrf9160_gps seem to also be ignored which means that it is difficult to set MAGPIO inside nrf9160_gps.c when referring to the value CONFIG_NRF9160_GPS_SET_MAGPIO

Also printk statements that are "greyed out" in the code actually appear when the code is running....

So...the project is all screwed up.

Oh dear...

Oh and if I load or try to Configure nrf Connect SDK project within Segger and then click on menuconfig

I'm shown Unable to parse json string

Any help would be great please

Parents Reply Children
No Data
Related