Cannot receive UART data

[mlease2020]

I'm using the nRF52 DK with SDK 15.3.0. At this point I'm trying to get a UART loop back to work by tying the TX pin (P0.8) to the RX pin (P0.9). I have verified that the RX GPIO is set for an input and the input buffer is connected. My project is based on the "ble_app_uart" project. I see what looks like reasonable data going out on the TX pin but I never get the APP_UART_DATA_READY event in the event handler. I do get the APP_UART_TX_EMPTY event after sending the string of 4 bytes but do not get any other events. I have also tried putting a 50mS delay after sending a byte with "app_uart_put" then calling "app_uart_get" and it returns NRF_ERROR_NOT_FOUND indicating no data to read.

Looking at the UARTE0 registers after sending the data, EVENTS_RXSTARTED is a 1 and EVENTS_RXDRDY and EVENTS_ENDRX are both 0. The ENDRX interrupt is enabled, the RXD PTR is set to an address in RAM, the MAXCNT is 1 and AMOUNT is 0.

Here is my UART initialization code:

Fullscreen

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

17

18

19

20

21

void uart_init(void)

{

uint32_t err_code;

app_uart_comm_params_t const comm_params =

{

.rx_pin_no = PIC_TXD_BITNUM,

.tx_pin_no = PIC_RXD_BITNUM,

.rts_pin_no = 0xffffffff, /* indicates pin isn't used */

.cts_pin_no = 0xffffffff, /* indicates pin isn't used */

.flow_control = APP_UART_FLOW_CONTROL_DISABLED,

.use_parity = false,

.baud_rate = NRF_UART_BAUDRATE_115200

};

APP_UART_FIFO_INIT(&comm_params,

UART_RX_BUF_SIZE, /* 256 byte buffer */

UART_TX_BUF_SIZE, /* 256 byte buffer */

uart_event_handler,

APP_IRQ_PRIORITY_LOWEST,

err_code);

XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX

void uart_init(void)
{
    uint32_t                     err_code;
	
    app_uart_comm_params_t const comm_params =
    {
        .rx_pin_no    = PIC_TXD_BITNUM,
        .tx_pin_no    = PIC_RXD_BITNUM,
        .rts_pin_no   = 0xffffffff,									/* indicates pin isn't used */
        .cts_pin_no   = 0xffffffff,									/* indicates pin isn't used */
        .flow_control = APP_UART_FLOW_CONTROL_DISABLED,
        .use_parity   = false,
        .baud_rate    = NRF_UART_BAUDRATE_115200
    };

    APP_UART_FIFO_INIT(&comm_params,
                       UART_RX_BUF_SIZE,                            /* 256 byte buffer */
                       UART_TX_BUF_SIZE,                            /* 256 byte buffer */
                       uart_event_handler,
                       APP_IRQ_PRIORITY_LOWEST,
                       err_code);
    APP_ERROR_CHECK(err_code);
}

I get the same results with two nRF52 DK boards. Any ideas?