Problem with connecting to device

[carribus]

After not having used my Thingy52 for a number of months, I decided to get back to tinkering with it.

When switching it on, it briefly shines a red light and nothing else. I have put it on charge for a number of hours (with the power switch ON) and am still not able to discover the device.

Apart from the brief red light shine on and off when I put the power switch on, nothing else happens.

What am I doing wrong? Is my device broken?

[ovrebekk]

Hi 

Have you ever changed the firmware in the Thingy, either by using the DFU mechanism or by connecting a programmer to the 10-pin J-Link port?

Will it work if you turn it on while it's charging over USB, or does it behave the same in this case?

Could you try to turn it on while keeping the button pressed to see if the bootloader is still available?

Best regards
Torbjørn

[carribus]

Hi, I have never updated the firmware.

I see the same behaviour when turning it on while charging and when its not connected.

I will try holding the button pressed while switching it on later today and report back. Is there anything I should be looking for when doing so? Will the light start breathing or stay on?

[ovrebekk]

Hi 

The light should start pulsing yellow when in DFU (bootloader) mode. 

The key is to keep the button down at the moment you turn it on. 

Best regards
Torbjørn

[carribus]

Hi,

So I tried holding the button down while starting the unit. There is no yellow pusling light present. The only difference is that the red light flash is delayed by a second or two when holding the button.

[ovrebekk]

Hi 

Could you try to measure the VDD voltage on the Thingy with a multimeter?

If you remove the rubber cover you can access GND and VDD on the P4, P6 or P8 headers. 

Best regards
Torbjørn