NRF52840 dongle is not working after selecting recover option in NRFgo studio

[Saagar]

HI 

I am programming NRF52840 dongle using nrf52840 dk 

i have flashed blinky code to my nrf52840 dongle it programmed sucessfully after that i have erased the dongle by selecting recover option in nrfgo studio from then my dongle is stopped working.

Thanks and Regards

[Einar Thorsrud]

Hi,

nRFgo Studio is not compatible with the nRF52840 dongle. However, it should be able to cause any problems either, since nRFgo Studio needs a debugger. Can you double-check that you are using a nRF52840 dongle and not a nRF51 dongle? Or that you are using nRFgo Studio and not nRF Connect for Dekstop?

If you are using a nRF52840 dongle, then please try to program it again from nRF Connect for Desktop Programmer. You may need to press the sideways reset button to get it into USB DFU mode, which is required in order to be able to program it. You will then see a red pulsating LED indicating that it is in DFU mode.

[Saagar]

HI 

I am using nrf52840 dk to program nrf52840 dongle and  i have programmed the blinky application and it was running sucessfully and after that to erase the board i have selected recover option in nrfgo studio and after that it stopped working

[Einar Thorsrud]

Hi,

As mentioned, it seems you have erased the UICR of the chip (as part of the full chip erase). Therefore, the board chip has a too low VDD voltage to be debugged from a DK. The procedure is described in detail in the last part of the nRF52840 Dongle Programming Tutorial.

You have two options. Either use a professional debugger with a level shifter or modify the dongle HW to use a higher supply voltage. If the first is out of the question, then you need to:

1. modify the dongle as explained in detail under External regulated source.
2. Power the dongle from an external regulator that is about 3 V
3. Now program the device via a debugger (for instance the DK can be used now). Make sure that the hew firmware properly configures REG0. (see nRF52840 Dongle Programming Tutorial for details).

[Saagar]

Thank you for your responce 
I will try this one

[Saagar]

After doing the above procedure the dongle is not detected and getting some mV from VOUT ..initially it was giving 1.8 v ..

connections

3v3  ------------------  VOUT

SWDIO ------------- SWDIO

SWDCLK -----------  SWDCLK

GND  ----------------  GND

Thanks and Regards

[Einar Thorsrud]

Hi,

Did you cut SB2 and solder SB1?

What do you mean by "getting some mV from VOUT"?  After this modification, you need to supply the dongle at the VDD OUT connection point via an external supply. Did you do that?

[Saagar]

Ya i have given external power supply to VOUT. swdio and swdclk from nrf52840 dk

[Einar Thorsrud]

Hi,

By VOUT, you mean VDD OUT, right (see image)?

This is where you should apply the supply voltage.

What did you mean by "and getting some mV from VOUT ..initially it was giving 1.8 v .."?

As I understand you already had debugging working with the nRF52840 DK before this issue, and the connection to the debugger should remain exactly the same (like you listed, including GND detect).

[Saagar]

Hi 

Thank you very much now i am able bring my dongle back to working 

Once again thank you very much for your support