This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

nRF51DK not running after programming through nRFGo studio

Hello,

I am using nRF51 DK and it is programmed with s130 soft device and uart application hex file with nFGo studio.

It programmed successfully but device not showing in app and also the advertising LED not blinking.If i debug in segger then it works fine.

(uart code ported in segger).

Plz. help.

I read in dev zone that need to reset the device after programming through nRFGo studio or have to give external supply.

I am using USB instead of external supply or coin cell.

Thanks in advance

Parents Reply
  • Hi, Thank you.

    The issue resolved when my application code build using keil and then programmed and the device advertising successfully.

    Previously my code was in segger Embedded studio, and evrything works fine in debug mode but problem when I flash using command tools, program flash successfully but it not advertising.

    But what exact issue don't find, it works fine when I flash the hex file which build on keil and if same code build on segger then it works only in debug mode, and not works when flash.

    Thanks & regards,

      Archana 

Children
Related