This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Softdevice S310 and interrupt

Hi support team,

I would like to know if the following behavior is a normal behavior: My config: NRF51422 AAE0 + S310 V2.0

When I enable some inetrrupt like UART for example, soon I enable the softdevice by calling sd_softdevice_enable() function, the interrupt previously activated are disabled. I've looked the Interrupt Enable control register @0xE000E100 before and after the sd_softdevice_enable() function.

Is it the normal behavior?

Thanks, Bruno

Parents Reply Children
No Data