Problems with Nordic Power Profiler Kit- doesn't work

[Mikhail]

Hi!

I seen video and read manual how to use it, but still not doesn't work.

PPK + PCA10040

on the PPK board I set jumprs to DK (all 3 pcs). USB connected to PCA10040. Application was loaded to it and LEDS are blinking.

PPK application runs and connect correct but doesn't measure anythink.

What possible problem?

[Susheel Nuguru]

Did you prepare the board as mentioned here cutting the solder bridge?

[Mikhail]

I have nRF52832 dev doard. Means, SB9 should cut?

[Mikhail]

DUT switch toward to External, Below scwitch Power select toward to DK, switch like above in the red oval in EXT position. USB connected to DK10040

is it correct?

Run PPK application via nrf connect and it no asks me to update firmware.

What I do wrong?

[Mikhail]

Sorry, but in this video

https://www.youtube.com/watch?v=JBKeHlOcO_g&t=82s

man shows how it works. He has same DK board, he is DUT switch toward "DK" posision. Not to external, like you told.

At this configuration aslo doesn't work.

[Mikhail]

Also LED2 on the PPK board doesn't light.

May be really PPK board wrong?

[Mikhail]

Hi! 

Have no idea? May be really the my board is broken?

[Susheel Nuguru]

If you tried everything i said, then it might be that your board is broken.