This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

nRF51822 development setup on a linux machine

Hello everybody... I am new to nordic development tools. I wanted to develop a ble application on the nRF51822 development kit. I am struggling to figure out how to set up the nordic SDK and gcc tool chain on a linux machine. I would appreciate if someone could guide me through the process of setting up on linux... Thanks

Top Replies

Parents

0 Marcel Mulder over 10 years ago

Hi,

There is no problem to do the development with linux or on Mac OS X. I am using this toolchain. As an IDE I use QT-Creator using qbs projects. See ST-LINK nrf51822 and QT Creator. Debugging and programming of flash is done using the Segger JLink tools.

I am lacking time to elaborate on this now, but I am planning to make a blog about this in the near future.
Cancel
Vote Up +2 Vote Down

Cancel

Reply

0 Marcel Mulder over 10 years ago

Hi,

There is no problem to do the development with linux or on Mac OS X. I am using this toolchain. As an IDE I use QT-Creator using qbs projects. See ST-LINK nrf51822 and QT Creator. Debugging and programming of flash is done using the Segger JLink tools.

I am lacking time to elaborate on this now, but I am planning to make a blog about this in the near future.
Cancel
Vote Up +2 Vote Down

Cancel

Children

No Data