AT%XRFTEST=1 at not supported Band with the nRF9160

[Otti]

Is it possible to send a CW signal at 806 MHz with the command "AT% XRFTEST = 1". The frequency 806 MHz is downlink from band 20. To optimize the antennas it would be ideal if one could also transmit on this frequency. With the command "AT% XRFTEST = 1", the band must also always be specified and 806 MHz and band 20 do not match. Is there a test band on which all frequencies work?

[Hakon]

Hello,

this post mentions that "No, XRFTEST should return an error if you try to give it a combination of rx/tx and band/freq which is not according to 3GPP spec.".

It should not be possible to transmit on a frequency that's outside the band. I don't think there is a band that supports all frequencies.