ADXL345 with nrf52840

[saver]

i want to interface the adxl345 accelerometer with the nrf52840 board 

i got an code from ADXL375_12C.zip

https://devzone.nordicsemi.com/cfs-file/__key/communityserver-discussions-components-files/4/ADXL375_5F00_I2C.zip

 line 51:ret_code = nrf_drv_twi_rx(p_twi_master,slave_addr, pdata, bytes, false);

in adxl375 too many arguments to function 'nrf_drv_twi_rx'

why it comes when i execute the program in twi_sensor program

and how to change the code for adxl345

[awneil]

saver said:

too many arguments to function 'nrf_drv_twi_rx' why it comes when i execute the program in twi_sensor program

For exactly the reason it says!

What SDK version are you using?

What SDK version was that code written for?

A link to the discussion would help

saver said:

how to change the code for adxl345

It has nothing to do with the ADXL

It is a basic rule of 'C' programming: always make sure that you supply the correct number of arguments - no more; no fewer - in any function call

EDIT

Is this where you found the file https://devzone.nordicsemi.com/f/nordic-q-a/40822/adxl345-and-nrf52832/159190#159190 ?

That was over a year ago - so very likely not for the latest SDK ...

[saver]

I AM USING SDK 16 

IF THAT IS THE CASE WHICH SDK I SHOULD USE

[awneil]

well, if you want to just take that example and use it without modification, then you are obviously going to have to use whatever version that example assumes!

However, the ADXL - like any other I2C slave - neither knows nor cares what SDK you use.

The I2C slave doesn't even know what microcontroller you use - it just sees transactions on the I2C bus.

So your job is to use the facilities of the SDK to generate those transactions.