HardFault of SystemInit

[Price Wang]

Hi,

I'm trying to deploy the example program, cifar10, from CMSIS-NN library on NRF52. The issus is I compiled and downloaded it to the board successfully but when I try to debug, it alwasys stays in HardFault_Handler.

I checked the code and found the problem occurs when I referenced a variable "conv2_wt", which is an INT_8 array with length 32*5*5*16=12800. (If I delete this line the program will be OK)

I guess the problem is about the stack size or something like that but I dont konw how to fix it.

Thanks.

[Håkon Alseth]

Is the variable conv2_wt stacked, or a globally declared variable? If stacked, then you're running out of stack memory. You can either expand the stack size (Keil: options for project -> ASM -> define: __STACK_SIZE=larger than your array), or declare it as a global.

 

Kind regards,

Håkon

[Price Wang]

Hi Hakon,

The variable conv2_wt is a global variable. I checked the stack I defined and I think it's large enough.

[Håkon Alseth]

The nrf52832 has in total 64 kB of RAM. You shouldn't declare it all for the use of stack. Remove that define if your array is globally declared.

When in debug mode, you should get a call stack when you reach the hardfault handler, listing which functions lead to the fault. Could you post this?

 

Kind regards,

Håkon

[Price Wang]

In debug mode, I did those operations:

1. Proceeds ok up to "LDR R0, =SystemInit"
2. On the next instruction, BLX R0, the code jumps correctly into SystemInit
3. Using single step instruction mode, it just went into hardfault handler (the asssembly is a push function)

[Håkon Alseth]

Hi,

 

Here's a window that shows the call stack in the lower right corner, which shows what functions I'm in:

 

However; I see from your stack pointer that this isn't going well. Its set at 0x20014418, which indicates that approx. 82 kB of RAM is used. This will not run properly, as the nRF52832 has 64kB of RAM.

As previously mentioned, please remove the __STACK_SIZE=64k that you have in your project, re-compile, and enter debug mode again to see if the fault occurs. If it occurs, please post the whole picture of the IDE.

 

Kind regards,

Håkon