Timeout Resolvable Private Address

[nobody_19]

Hello

Where is the the timeout for the Resolvable Private Address (RPA) defined?

• only possible in the central?
  • can I change the timeout in the android nrfConnect App? (For Testing my application?)
  • is there another test application where I can change the timeout?
• also possible in the peripheral with min/max timeouts?

What happens when central or periperals are trying to reconnect after one device was powered off (last RPA lost)? 

[Jørgen Holmefjord]

Hi,

There is no timeout, but you can set the private_addr_cycle_s to the interval at which you want the address to be updated by the softdevice (default is BLE_GAP_DEFAULT_PRIVATE_ADDR_CYCLE_INTERVAL_S). You can also use a timer in your application to update the address yourself.

Maximum address update interval is set by BLE_GAP_MAX_PRIVATE_ADDR_CYCLE_INTERVAL_S.

As far as I know, there is no way to change the address settings in nRF Connect App, it will use the default from the phone OS/HW.

If the devices have established a bond, the address can be verified using the IRK. This thread has some good information.

Best regards,
Jørgen

[nobody_19]

So now I am a bit confused.

I am trying to bond an android 9.0 (central) smartphone and a nrf52832 with the SD 4.0.2 (peripheral).

So which one is defining the the RPA change interval?

• Central
• Peripheral
• Both (lower cycle interval)?

Is the android device allways doing a RPA change, also when the peripheral is not able to do that?

For what I have to verify th ethe IRK?

Should not after I bonded succesful, the whitelist be updated with the IRK, IRK count etc.? 

Did I understood it correct,the softdevice does not stores the IRK permanently? That is the task of my application?

Thanks a lot