The command of ./UartSecureDFU ttyACM0 dfu_app_pkg.zip has no response!!

[QingF]

Hi:

       I  use the sdk https://github.com/jimmywong2003 to make a bin file and then run the command of ./UartSecureDFU ttyACM0 application.zip to updgrade in linux

It always has no any response ! It seems the command can not finished forever ! I do not know what it happens.

Please give me some ideas!!

Thanks

Best Regards!!!

[Jimmy Wong]

Hi

you can add the -v -v to print out the log.

Also, please make sure that the board is correct the port.

[QingF]

Thanks for your advice!!

I check the BaudRate is not matching with 9600 in my project. I changed it and then try again,

It shows: Sending Application image   as follow:

It's been going on for more than ten minutes！The application.zip is only 102.0KB.

[Jimmy Wong]

The example is testing to work with SDK 14.2 and nRFUtil 3.4 version.

You need to double check on your configuration.  Suppose you can use higher baud rate.

[QingF]

Hi Jimmy Wong!

I have added the -v -v to print out the log.But do not know Where is the log and What the name of the log file is!

if I should gived its name ex; -v -v name.log

[Jimmy Wong]

Hi 

it should show on the screen (as standard output).  

You should see the similar screen as below.