This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

Build and run - not running immediately

Hi,

I ported an nrf example from nRF5 SDK version 12.3.0 ble_proximity to segger studio (v4.50), and flashed into nRF51DK, using build and run option. The application is not running immediately but runs after pressing boot reset it works normally. The application can also starts on power-up. Is there any reason that not running immediately after flashing?

Thanking you

Ras

Parents Reply
  • Hi,

    Thanks for the reply. Yes, I can use debug and run, but when it was not running after build-and-run option, I initially thought there were issues with my program. As I am not developing anything seriously for nRF51, it is not a big issue. I found similar post in Segger forums but not solved. I will use reset button to run.

    Regards

    Ras

Children
No Data
Related