This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

Kiwi project: RGB led

Hello,

Because I have no space for additional transistors on my board I made a design with nrF52840 and rgb led connected to 5V. 

Configuration o GPIO pins:

H0D1 Value=7 High drive '0', disconnect '1' (normally used for wired-and connections)

If leds are switched off the voltage at the ports P0.19, P0.24, P0.25 are increased over VDD (3.3V) until around 3.6V.

Can I accept this or can the ports break?

Related